(ON RAMP) ELECTRICAL UNIT PRESERVATION Step 5. Insulate all wiring with ignition insulating compound, both in engine compartment and under dash, Seal all openings (i.e.) air cleaner, oil filter hole, generator, starter motor, tail pipe, with grease-proof paper cover with sealing tape compound. Then spray entire engine block with ignition insulating compound. Step 6. (ON RAMP) THIN FILM APPLICATION Spray entire chassis, under carriage, hood hinges, wheels inside and out, -- if hub caps, remove and spray. Step 7. TOW TO STORAGE AREA. STORAGE SITE Replace spark plugs. Wrap seats with water-proof paper. Put on blocks. Remove wheels and apply zinc chromate on brake drums. Depress clutch pedal and wedge in depressed position. All brakes in released position. Deflate tires to 50% normal pressure and cover tires with water-proof paper. Compressors shall be disassembled sufficiently to 3-34. COMPRESSORS, 3-35. Remove all organic packings (except Neoprene) and attach to out- conduct the degree of processing required for metal-working machine tools. After performing the operations specified in 3-35 through 3-37, the compressors shall be rezssembled. side of machine for reference at time of reactivation. 3-36. Remove connecting rods, crosshead, piston rods, pistons, piston rings, and compressor valves and clean and preserve internal surfaces and parts. 3-37. Disassemble oil pump, clean, preserve, reassemble, and remount. Drain all systems of the compressor and clean and spray all exterior anc interior machined surfaces with type P-3 preservative. 3-38. ORGANIC PACKINGS. The removal of organic packings is specified throughout this specification. This is to prevent these materials from attaching ferrous metal surfaces or plunger shafts amd cylinder walls. When the packings are neoprene they need not be removed, or when the metal surfaces that the organic packings come in contact with are nonferrous (brass liners, etc), the packings need not be removed. 3-39. Preservative materials. strength. All preservatives shall be applied full The resultant coating shall be uniform, continuous, and in all cases shall comply with the applicable preservative specification, Preservatives shall be kept well mixed to assume uniform texture prior to application. 3-40. Preservative application. All surfaces shall be dry before preservatives are applied. Dry rags, infra-red banks, compressed air, or 18-34