APPENDIX 1 ~ANNEX 0T TO OPFRATIONS ORDER NO, 2- SCOPE CONTROLLER INSTRUCTIONS SCOPE CONTROLLER #1: Wilk begin his duties at start engine time for the first VIKING aircraft in Annex C (Aircraft Mission Execution Chart), He will check Scope #1 and VHF Channel © to insure they are functioning properly and have his teller check his communications with the effects status clerk and plotter #1. He will monitor VHF Channel C from take-off for first VIKING aircraft in Annex C, to receive a call from VIKING aircraft when approximately ninety (90) miles from Rniwetok on course to assigned mission stations in Annex D (Aircraft H-Hour Positions and Flight Patterns), When positive control is established with each VIKING, the teller will give the status clerk the time control is accepted and start three minute position reporting to the plotter, The controller will give all VIKING aircraft range and bearing to their assigned mission stations and tell them to fly a loose orbit-when on station. When each VIKING air‘craft reaches mission station, position three (3) will be reported to the status clerk, The controller will continually monitor the VIKING aircraft flight patterns and inform them of their range from Ground Zero to insure that no VIKING is closer to Ground Zero than prescribed in Annex D (Aircraft H-Hour Positions and Flight Patterns), Controller #1 will request VIKING aircraft to switch to Channel B and maintain radio silence for the following time hacks: H-l hour and 2 minutes for H-l hour hack. K-32 minutes for H-30 minute hack. H-17 minutes for H-15 minute hack, H-3 minutes and remain on B until after H-hour. After H-hour, the controller will standby to receive the time of departure for each VIKING aircraft. SCOPE CONTROLLER #2: Will begin his duties at start engine time for PEWTER 2 in Annex C (Aircraft Mission Execution Chart). He will check scope #2 and VHF Channel H to insure that they are functioning properly and have his teller check his communications with the effects status clerk and plotter #1. He will monitor VHF Channel H from take-off for PEWTER 2 in Annex C, to receive a call from PEWTER 2 when approximately ninty (90) miles from Rniwetok on course to assigned mission station in Annex D (Aircraft H-Hour Positions and Flight Pattern), When positive control is established with PENTER 2, the teller will give the status clerk the time control is accepted and start three minute position reporting to the plotter. The controller will give PEWTER 2 range and bearing to his assigned mission station. When PEWTER 2 reaches mission station, position three (3) will be reported» the status clerk, The controller will place PEWTER 2 in a starboard race track pattern. with approximately three (3) minute legs broadside to Ground Zero, The controller will provide PEWTER 2 with range from Ground Zero each time he passes through his assisned true bearing from Ground Zero, Range will be given on boti North ond South headings. The controller will provide position reports and uccessary vectors to insure PEWTER 2 meeting his H-hour position within ecccpted tolerance of plus or minus fifteen seconds. Immediately after H-hvur, PEWTER 2 will fly at his own discretion to photograph cloud for approxi- mately fifteen (15) minutes, The controller will continue to track PEWTER 2 and give him range and bearing to base upon completion of mission. When PEWTER 2 departs cloud area for base, the teller will give position four to the status clerk. The controller will maintain control until control is accepted by DIRTY FACE at which tine position five will be told to the status clerk. Scope Controller #2 will have PEWTER 2 switch to Channel B for the foliowing time hacks: H - 2 hours and 2 minutes for H ~ 2 hour time hack. H ~ 1 hour and 2 minutes for H- 1 hour time hack. TASK GROUP 7.4 ~~ =