CHAPTER I!, SECTION 3 to enter the station from detector Stations 1318 .02 and .03. Two new coaxial cable air dryers were required. Power requirements were 15 KW, 120,208 volt, 3-phase. Five timing signals and a go-no-go-circuit were to be provided. Rehabili- tation started on 21 April 1956 and, at User request, was stopped at 50% progress due to the cancellation of the Pawnee event. 1318.02 Alpha Detector Station Janet DOD-13 5 USER: 1318.03 feet thick walls. A tunnel 24’ x 16’ x 15’ high ex- tended from one end of the building to the cen- ter of a 66’ long 3’-thick retaining wall. Approximately 10 of earth covered the tunnel and building. Because of the high loadings, the main rein- forcing was placed in two layers throughout most of the structure, and stirrups were install- ed in the mannerof straight reinforcing in sev- eral layers and parallel to the main reinforcing. Within the building, two heavy lead doors re- The tunnel entrance at the retaining wall contained a 3’-6” x 9-6” steel-framed blast door. 5 Station 1316, Yvonne, with exceptions as noted below. The concrete bin was located on only one side of the detector cubicles, and only three each 3’x4’x3’-6” detector cubicles were re- quired. Three 12”-pipes were to be used with a clear line of sight to the working point of Station 5. The working point of the detector heads were to be 20” above the cubicle floor. Progress - 4-12-56 quired casters at the floor to support the weight. Detector Station Janet This station was designed for use similar to Me anccol 1319 Alpha Recording Station Charlie LASL 18 12-12-55/5-5-56 Station 1319 was a reinforced concrete building 26’ x 31’ x 15’ high with 51% to 6% work was stopped on this station at the progress stage of 67% complete because of the cancellation of the Pawnee event. PURPOSE: SITE: STATION: SITE: SITE: USER: PARTICIPATION: CONSTRUCTION: OCCUPANCY: This station was to be a User-furnished detector mounted on a portable wooden skid and connected to Station 1317 with coaxial cable. On 16 May 1956 and at User request, STATION: was stopped due to cancellation of the Pawnee event. Power was provided by two 30 KW, 120/ 208 volt, 3-phase portable diesel engine-driven generators mounted on a concrete slab approximately 45 feet from the station. One generator provided power for normal needs; the other was used as a stand-by unit. A 10 KW dummyload was tied into an automatic transfer switch so that the stand-by generator was loaded when not used for station power. Each generator was connected into a 36-circuit power panel through wet -~ monge. “ ~ vf STATION: PURPOSE: SITE: USER: PARTICIPATION: of this station reached 67 percent when work aes man ae 7 ' - f =e oo e ae Figure 2-72. Page 2-86 8 eaa Ek s ‘~ ae a Se x. - i tm, 2 oe a oo pcr natnag . + Atanas Tal oa Station 1319 - 72% Complete