SECTION FENCING AND GATES 12-01. SCOPE OF WORK: The work covered by this section of the specifications includes the furnishing of all labor, materials, equipment and tools necessary for the complete installation of all fencing and gates as indicated on the drawings or required for the work. 12-02. WORK NOT INCLUDED: The following items of work shall be as elsewhere called for in the specifications. a. Concrete footings and floor slabs for fenc ing and gates shall conform to the "Concrete and Form Work" section of these specifications. 12-03. MATERIALS: a. General Requirements: Contractor shall furnish and erect fencing and gates as indicated by design on the drawings, and shall comply with Federal Speci- fications Nos. RR-F-183, RR-F-191 (as amended) and RR-F-22] unless as otherwise indicated or herein specified. 1. Chain link fabric’shall be No. 9 gage, 2 in mesh zinc coated chain link with top and bottom selvages twisted and barbed. Weight of flabric shall be approximate- ly 0.33 pounds per square foot. ° 2.2-BarLéd wire shall be four oint regular type wire, zinc coated, consisting of cee ot“1a strands unless otherwise indicated on the drawings) of twelve (12) (B37 wire twisted with thirteen (13) gage barbs spacec inches apart and shall conform to Federal Specifi- ote RR-F-221, The wire shall be stretched taut and secured to each post with No. 14 gage wire bands twisted. 3. Line posts shall be 2-3/8 inch 0. D. zine coated steel pipe, weighing 3.65 pounds per lineal foot spaced not to exceed ten (10) feet on centers. 4. Corner and end posts shall be three (3) inch 0. D. zinc coated steel pipe weighing 5.79 pounds per lineal foot 5. Pedestrian gate posts (for openings less than 8'-0") shall be as above specified for corner posts. le-1