HYDRAULIC GOVERNORS Assemble one end of the adjustable control link to the bracket control lever. Assemble the opposite end of the adjustable control link to the governor lever in the third tapped hole from the serrated end. (Do not assemble the governor lever to the serrated shaft at this time.) Set the adjustable control link to 44" between the lock nuts by turning the link rod. The link has right and left hand threads, Set the hand control at full throttle or against the adjusting screw stop. Set the throttle arm so the rod measures 6}" to 6-3/8" from the distributor disc cover on top of the fuel pump to the bottom of the screw head which secures the rod to the arm and lock in place. NOTE: This is a preliminary setting that may have to be altered slightly after the following adjustments sre completed and the engine started. Any change in adjustment made here must have a corresponding adjustment made on the adjustable control link. Set the throttle lever in "OFF" position. 10, Turn the "load limit" kriob to 10. Turn the governor control shaft until the arrow of the knob on the dial marked "load limit" is at 10. ll. Pull the governor control shaft from the housing until the sharp edge of the small notch on the shaft is even with the boss on the fuel pump housing. 3-22