L.
PMADS
Loaded and started as described above.
spectrum for each pm tube.
need adiustment,
mented.
Program acquires individual
Waits for operator to compare photopeak.
program loons until adiustment is completed.
Operator need only to follow insecuctions in program.
If tubes
Program docuSee Part = of
this section for specific instructions.
2.
CURMOYV
Loaded as stated in steps 3.14 through B.17.
Loaded only iato buf-
fer #2 and executed when cursor move push button is selected or when button
below rotary switch #2 is pressed.
After >ushing button, system asks “ADC#:”.
Cperator responds with the number 1 or 2 then CR.
System will then prinr our
the current Live cine and preset live tine of selected ADC and the channel #
plus content of the cursors plus 3 channels above and below cursor.
3.
STANDAR3
Program loaded as stated in the introduction to this section.
Pur-
pose is to create standards which can be used in the matrix reduction progran
Alphal from existing spectra.
Special instructions for use follow in next
section.
4.
STANDARS
Program loaded as stated above.
spectrum at time of data acquisition.
5.
Purpose is to create standard
Program operation is selfexplanatory.
ALPSAL
Program {s loaded as stated in section instruction.
Spectral length cannot exceed 256
analyze Nal spectra acquired on TP-50.
channels.
Purpose is to
Program operation is not well documented.
Part C for specific operational instructions.
8
See cperation procedures