4

Second coat shall be "Nalco Synthetic Finish"

color No. 5269 Silver Gray, reduced by adding 1

thinner (Dutch Boy "Tex-Thin") or approved equal.
unreduced.

of minera]

Third coat shall be as second coat except apply

e-

Finish Floors shall be first coat,

Dutch

Boy No. 4662 "Clear Resin Sealer" reduced by adding 10% of

mineral thinner, or approved equal.

Second coat shall be

Dutch Boy "4 Hour Floor and Interior Varnish" (clear) or

approved equal.

-3. Aluminum Walls and Ceilings (where vapor
seal coating is required) shall be of "Cocoon" surface pre-

paration applied by air brush,

and should result in a plas-

tic film over all interior of walls and ceilings indicated

to be so insulated.

Care shall be taken that all holes,

cracks and other openings to be completely filled and sealec
to form a complete vapor barrier,
the Engineer.
4.

Dark Room:

to the satisfaction of

Over unfinished wood surfaces

apply a first coat of Dutch Boy No. 600 interior primer
and sealer and a second coat of Dutch Boy No. 320 flat

black quick drying enamel or approved equal.

Over surfaces

covered with "Cocoon" insulation apply one coat of Dutch

Boy No.
equal,

320 flat black quick drying enamel or approved

5.

Wainscote:

Where shown on plans or so di-

rected, wainscote to be painted to a height of 5'-0" above
floor level. Paint shall be as specified in item (1) of
this paragraph except second and third coats which are to

be Dutch Boy "Nalco Synthetic Finish" color No. 387 gray
or approved equal.

6.
Insulated Pipe & Fittings:
First coat
shall be Dutch Boy “Lead Mixing O11” reduced 20% by adding
mineral thinner or approved equal.
Second and third coats
shall be aluminum paint as specified in paragraph 2b of
this section.

7. Uninsulated Iron and Steel Pipe and Fittings shall be the same as item (5) in “Exterior Painting
Schedule" below.

8.

Ferrous Metalwork:

First coat shall be

Dutch Boy No. 1001 "Zinc Chromate Primer" or approved equal
as specified in paragraph 2f of this section.

Second and

third coats shall be as specified in item (1) of this par-

agraph.

10-7

Select target paragraph3